FAQs

Resetting Device to Factory Default will erase all the user’s configuration, preference,

database and profiles on the device and restore the device back to the state as factory default. 

To perform a factory default reset, user should press [Menu] >> [Advanced],

and then input the password to enter the interface.

Then choose [Factory Reset] and press [Enter], and confirm the action by [OK].

The device will be rebooted into a clean factory default state.

                                        Topology

Purpose:

This is an intercom demonstration setup between doorphone (HDP-1160PT) and video intercom (VTS-700P) via P2P to open the door lock.

1. VTS-700P configuration

This is the setting to trigger the door lock via DTMF protocol.

2. HDP-1160PT Configuration

3. HDP-1160PT è Door Lock connection

4. To open the door lock via VTS-700P

    A. Press the Janitor tab first.

    B. Then press the Key tab to open the door lock.

Purpose:

This is an intercom demonstration setup between IPX-330,doorphone (HDP-1160PT) and IP Phone (ICF-1900);all devices will be registered with IPX-330.

All doorphones will call IP Phone_1 first,and it will forward to IP Phone_2 if it’s busy or there is no answer.

1. IPX-330 Configuration {extension 801~806}

Enable the video call option on extension (801 ~ 806) separately as shown below: 

Configure the call forward function.If IP Phone_1 (801) is busy or there’s no answer,it will forward

to extension 802 as shown below:

2. ICF-1900 configuration for IP Phone_1

Configure the Function key for HDP-1160PT (803~806) separately as shown below: 

3. ICF-1900 configuration for IP Phone_2 

4. HDP-1160PT configuration (803~806)

    For example, the ext. 803 configuration

Purpose:

This is an intercom demonstration setup between doorphone (HDP-1160PT) and IP Phone (ICF-1900) via P2P.

1. ICF-1900 configuration

For SIP 1~SIP 3,please enable the checkbox of “Dial Without Registered” as shown below:

For SIP 1~SIP 3,please disable the checkbox of “Enable Strict UA Match” as shown below:

2. HDP-1160PT configuration (Every HDP-1160PT should have the same configuration as shown below.)

To recover the default IP address and password, please follow the following steps.

The default IP address of the LAN port is 192.168.0.1.

You can change IP address when logging in the device configuration page.

Please make sure you PC has added an IP address that has the same range as 192.168.0.x/24 (Like 192.168.0.2/24).

The default username and password are : admin/admin.

You can change username and password on the configuration page.